Unless otherwise indicated, information contained in this site is Copyright © 2009-2017 VIDAR Systems Corporation.Īll Rights Reserved. VIDAR Systems Corporation 365 Herndon Parkway Herndon, VA 20170 You need JavaScript enabled to view it.ġThe STI driver takes advantage of Microsoft's Still Image Architecture (STI) for digital imaging devices.Ģ(Advanced SCSI Programming Interface) An interface specification developed by Adaptec, Inc., Milpitas, CA, that provides a common language between drivers and SCSI host adapters.
This email address is being protected from spambots. If you are not able to burn a CD, please request the VIDAR Toolkit and Driver CD from
DOWNLOAD USB DRIVER FOR WINDOWS XP INSTALL
Then burn the files to a CD and install according to the Setup Guide. After downloading the Driver CD zip file, unzip the files to the hard drive. IMPORTANT: The Driver CD files must be burned to a CD for the autorun installation program to run. For driver installation instructions, please download the Setup Guide. VIDAR Driver Installation CD version 3.0 - This CD is now being shipped in the Installation Manual with new hardware products. Windows 2000 Service Pack 4 SCSI or USB Interface The table below also outlines the CDs needed for each operating system. Complete instructions for all supported and legacy systems are available at the Setup Guide links in the chart below. Instructions for installation are different for different operating systems, depending on whether you use a USB or SCSI interface. VIDAR supports the following Windows operating systems: VIDAR drivers support USB 2.0 (USB 1.1 is not supported).
DOWNLOAD USB DRIVER FOR WINDOWS XP SERIAL NUMBERS
Note that only digitizers with serial numbers 310000 and higher have USB interface capability. VIDAR has introduced a driver CD that can be used to install UB or SCSI drivers on Windows 2000 and XP operating Systems. Support for Adaptac ASPI 2 device drivers on Windows 2000 has been discontinued.Īfter installing the Adaptec 293 card in your PC, select and install the appropriate device drivers for your system to ensure proper communication between the digitizer and PC. VIDAR supports Windows XP ® 32 bit and Windows 2000 ® via STI 1via driver software. Device Drivers for Windows XP 32 Bit & 2000
0 kommentar(er)
